Face case70 Face

Honda Engineering Co., Ltd.

A world first: alternating blank stamping technology (in Japanese)

Cut line 1 ⁄ Cut line 2

Upper die

Upper die

①
Switching of the dies on the cut lines where the two lines intersect
②
Rollers outfitted on the lower die push up and drop scrap. This ensures smooth operation without leaving any scrap behind
Rollers outfitted on the lower die push up and drop scrap. This ensures smooth operation without leaving any scrap behind
③
Outfitting the lower die with a nylon brush maintain the position of the blanks from below and prevent the blanks from sagging down and being damaged
Outfitting the lower die with a nylon brush maintain the position of the blanks from below and prevent the blanks from sagging down and being damaged

Page Top

Honda Worldwide site

Home | Site Map | Site Index | About this Site

Copyright, Honda Motor Co., Ltd. and its subsidiaries and affiliates. All Rights Reserved.